1. After the cutter die setting work of the cross-cutting machine is completed, put the material to be cut on the rubber plate, then put the cutter die on the material, and then push the feed plate into the cutting area. ,
2. Press the 12 cutting switch of the cross-cutting machine with both hands. At this time, the cutting plate will be lowered and pressurized on the die. After the die cuts the material, it will automatically return to the position before starting and stop. ,
3. When cutting materials with a cross-cutting machine, if you find that the material has not been cut, adjust the 03 cutting depth controller to rotate the "pressure system" clockwise and counterclockwise; if the knife mold is pressed into the rubber sheet too deeply, The "pressure system" rotates counterclockwise. The longer the adjustment time, the deeper the cut. Try to adjust until the die is slightly pressed into the rubber sheet. ,
4. Pull the feeding plate out of the cutting area, take out the cut material, and complete the blanking process.
https://www.ksslitter.com
