Cutting machine skip blade reasons

Slitting machine has tensile, unwinding tension is not well controlled, unwinding as far as possible is automatic tension is more constant. If the slitting machine jump blade, there may be no maintenance and maintenance work. In order to ensure that the slitting machine is always in a good technical state, can be put into operation at any time, reduce the failure days, improve the rate of mechanical integrity, utilization, reduce mechanical wear, extend the service life of machinery, reduce the cost of mechanical operation and maintenance, to ensure safe production, we must strengthen the maintenance of machinery and equipment. The maintenance of the slitting machine must carry out the principle of“Lay equal stress on maintenance and give priority to prevention”. It should be maintained regularly and compulsorily. Maintenance slitting machine to ensure quality, according to the provisions of the project and requirements for item by item, shall not be omitted or not protected. Maintenance items, maintenance quality and maintenance problems found in the record should be reported to this department. Each team must do the maintenance work of all kinds of machinery according to the maintenance regulations and maintenance categories, without undue delay, and can only extend the maintenance after the approval of the specialized workers in charge under special circumstances, however, it should not exceed half of the required maintenance interval. To do the above, the slitting machine jump blade appears the probability of a lot less.