The normal operation of the slitting machine is the basis for ensuring the quality of production. Because, after each slitting machine runs at high speed for a long time, the running accuracy of some important key components will decrease. It is a bit difficult to ensure the running accuracy for cutting some small-sized film rolls. Because the composite film is a polymer product, its thickness is relatively thin, and it is easy to be damaged during processing. Therefore, when the running accuracy during slitting is not enough, quality problems such as longitudinal stripes are likely to occur on the film. For this reason, after years of observation and research, we have confirmed that the longitudinal stripes produced during slitting are the main quality problems in slitting and must be resolved.
When entering normal production, the speed of the slitting machine should be strictly in accordance with the process requirements. Too high will also affect the cutting quality. Therefore, by controlling the cutting speed well, the quality required for cutting can be obtained. Because, in the production, some operators artificially increase the slitting speed in order to increase the output and improve their own economic benefits, which will make the film prone to longitudinal stripes and cross-layer quality problems under high-speed operation. Therefore, in normal production, we must adopt an appropriate cutting process for production according to the performance of the equipment, the intrinsic properties of the film, and the different types and specifications of the film.
Because the process parameters, identification methods, and values of various cut films are different, the process must be carefully adjusted for each product. In production, the frequency of use of each station of the slitting machine is different, so the degree of wear is also different. Therefore, there will be a certain difference in performance. For example, there are fewer longitudinal stripes for products that are slitting at stations in better condition.
On the contrary, there are more vertical stripes. Therefore, each operator must pay attention to the correct selection of the station, give full play to the best state of the equipment, grasp the on-site use conditions, constantly sum up experience, and find the use method of the best characteristics of the equipment.
In addition, one more thing to note is that during the slitting process, each roll of film is reopened and rewound, which creates conditions for the entry of foreign matter from the outside, and because the film itself is mainly used for packaging food and medicine, Therefore, the hygienic requirements are very strict, so it is necessary to ensure the cleanliness of each roll of film.
May 26, 2023
Leave a message
How to ensure the normal operation of the slitting machine?
Send Inquiry





