Nov 26, 2025 Leave a message

How to Operate an Automatic Slitting Machine Correctly?

I. Pre-Operation Preparation

1. Safety Protection: Wear a safety helmet, safety glasses, and non-slip shoes. Check that the equipment's protective devices are intact.

2. Equipment Inspection: Confirm that the power supply and air supply are normal. Check the condition of components such as the transmission device and cutting device.

3. Parameter Settings: Set parameters such as cutting speed and tension according to the material type (e.g., paper, film).

II. Operating Steps

1. Start-up Procedure: Turn on the power, enter the main interface, and set the cutting size and quantity.

Start the automatic mode and adjust parameters such as traction speed and unwinding tension.

2. Cutting Process: Place the material on the cutting table, start the equipment, and keep your hands away from the cutting area.

Monitor the slitting effect and dynamically adjust the speed or tension.

3. Material Receiving and Shutdown: After cutting, unload the material and package it.

Turn off the power, clean the equipment, and record the operating status.

III. Precautions

1. Safety Regulations: Touching moving parts is strictly prohibited. Stop the machine immediately and report any malfunction.

2. Precision Control: Regularly check the blade sharpness to avoid overload causing uneven slitting.

3. Maintenance: Clean the equipment, lubricate the bearings, and check the pressure balance of the rubber rollers.

IV. Troubleshooting

1. Film Surface Scratches: Check for scratches on the roller shaft or uneven pressure on the rubber rollers.

2. Equipment Unresponsive: Confirm that the main power supply is on and the circuit is normal.

Paper Roll Slitting Machine for KWF-E

Send Inquiry

whatsapp

Phone

E-mail

Inquiry