1. Regular inspection and maintenance
Check the seals: Regularly check the seals in the hydraulic system, such as seals, gaskets, etc. If they are aged or damaged, they should be replaced in time.
Check the oil circuit: Make sure the oil circuit is unobstructed, check whether there is leakage in the oil pipe joints, and replace the seals if necessary.
Check the hydraulic cylinder: Check whether the hydraulic cylinder is leaking oil, especially the cylinder head and pipe joints. If oil leakage is found, replace the seal or repair the cylinder rod.
2. Correct installation and use
Install the seal: When installing the seal, ensure that the sealing surface is clean and smooth to avoid seal failure due to improper installation.
Use appropriate lubricants: Use appropriate lubricants according to equipment requirements and replace them regularly to prevent oil contamination or deterioration.
Control the pressure of the hydraulic system: Avoid excessive pressure in the hydraulic system to prevent damage to the seals due to pressure shock.
3. Environmental and operating condition control
Keep the equipment clean: Clean the surface and interior of the equipment regularly to prevent dust and impurities from entering the hydraulic system.
Control the working environment: Avoid operating the equipment in an environment with high temperature, high humidity or corrosive gases, as these conditions may accelerate the aging of the seals.
Avoid overload operation: Prevent the equipment from overspeeding or overloading to avoid failure of the seals due to overheating.
4. Professional maintenance and training
Regular professional maintenance: It is recommended that professional technicians conduct a comprehensive inspection and maintenance every 3-6 months to promptly discover and solve potential problems.
Operator training: Improve the technical quality of operators and ensure that they are familiar with the basic principles of the equipment and solutions to common faults.
5. High temperature protection measures
Check the insulation: Conduct a census of high-temperature pipes and valves near the oil pipeline to check whether the insulation is intact and whether there is any high-temperature exposure, and perform additional insulation or re-insulation to ensure that the high-temperature part has no leakage and the temperature of the insulation outer wall is not greater than 50°C.
Isolate heat source: For areas with major safety hazards, efforts should be made to isolate the heat source from the oil pipeline, and fully prepare for other unsafe problems that may be caused by oil leakage.





