Talking about the Causes of Slitting Machine Jumping Blade

The slitting machine has stretchability, and the tension of unwinding and unwinding is not well controlled, and the winding tension should be relatively constant by automatically adding tension as much as possible. If the slitting machine jumps, it may be that maintenance and maintenance work has not been performed.
In order to ensure that the slitting machine is always in a good technical state, it can be put into operation at any time, reduce the downtime of failure, improve the mechanical integrity and utilization rate, reduce mechanical wear, prolong the service life of the machine, reduce the cost of mechanical operation and maintenance, and ensure safe production. Strengthen the maintenance of mechanical equipment.
The maintenance of the slitting machine must implement the principle of "attaching equal importance to maintenance and prevention first", so as to achieve regular maintenance and mandatory implementation, and correctly handle the relationship between use, maintenance and repair.
The maintenance of the slitting machine must ensure the quality, and carry out item by item according to the specified items and requirements, and must not miss or fail to guarantee. The maintenance items, maintenance quality and problems found during maintenance should be recorded and reported to the specialized workers in this department.
Each team must do a good job in the maintenance of various machinery according to the machinery maintenance regulations and maintenance categories, without unreasonable delay. In special cases, the maintenance can only be postponed after being approved by the special worker in charge, but generally it should not exceed half of the specified maintenance interval. By doing the above points, the chance of edge jumping on the slitting machine will be greatly reduced.