The slitting machine is a pre-press that cuts a large roll of paper, film, non-woven fabric, aluminum foil, mica tape and other thin materials into small rolls of different widths. It is often used in papermaking machinery and printing and packaging machinery. So everyone knows the difference between the taper of the slitter and the control sheet?
The difference between the taper of the slitter and the control sheet is as follows:
1. The cost is different: the taper control cost is low. Constant tension control is better, but more expensive.
2. The coverage is different: the taper is the attenuation relative to the tension. The outer ring of the winding material needs to have a smaller tension than the inner ring, and the smaller is the taper setting value. If the tension of the outer ring is too large, the material will deform and shrink the tube.
The main feature of the slitting machine is that the magnetic powder clutch acts as a resistance device, which is controlled by the system to output a DC voltage to control the resistance generated by the magnetic powder clutch. When we all operate and use the slitting machine, the difference between the taper of the slitting machine and the control sheet is mainly described above. We all need to understand the above differences of this slitting machine. The correct way to operate the slitting machine is to use the slitting machine. What we all need.
