The slitting machine is a pre-press that cuts a large roll of paper, film, non-woven fabric, aluminum foil, mica tape and other thin materials into small rolls of different widths. It is often used in papermaking machinery and printing and packaging machinery. So everyone knows the difference between the taper of the slitter and the control sheet?
The difference between the taper of the slitting machine and the control sheet is as follows:
1. The cost is different: the cost of taper control is low. Constant tension control is better, but more expensive.
2. The scope of coverage is different: the taper is the attenuation relative to the tension, and the outer ring of the winding material needs to have a smaller tension than the inner ring. How much smaller is the taper setting. The material will deform and shrink the tube if the outer ring tension is too large.
The main feature of the slitting machine is that the magnetic powder clutch acts as a resistance device. Through system control, it outputs a DC voltage to control the resistance generated by the magnetic powder clutch. When we all operate and use the slitting machine, the difference between the taper of the slitting machine and the control sheet is mainly the ones introduced above. We all need to understand the above differences of this type of slitting machine. The correct way to operate the slitting machine is What we all need.
https://www.ksslitter.com
