Feb 19, 2023 Leave a message

Common faults and solutions of automatic slitting machine equipment

Common troubleshooting methods for automatic slitting machine equipment:
1. The winding of the automatic slitting machine is uneven, mainly because the paper core is not suitable. Just change the paper core to the desired inner diameter. In addition, during the winding process, winding pressure rollers should be used to avoid the problem of uneven winding.
2. The meter is not accurate. When this problem occurs, the two wheels of the counting wheel can touch the feed rubber roller at the same time, and mark the counting wheel. If manually counting 5 laps, count 1 meter, otherwise replace.
3. When the middle part of the semi-finished product is loose, it is closely related to uneven gluing and uneven substrate. At this time, the bow roller should be adjusted to make it support flat, or the tension of the unwinding shaft should be increased, and the substrate should be compacted with a knife tube.
4. If there are wrinkles when the semi-finished product is wound, the pressure of the tensioning cylinder can be appropriately increased.
5. When the finished product is coiled, whether the tension of the coiling shaft is too tight or closely related to the glue.
Automatic slitter is a very important equipment in paper processing, if there is a failure, the efficiency will be greatly reduced. Therefore, the staff usually pay attention to daily maintenance, find and solve problems in time, and there will be no problems in the production process.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry