1. Daily Basic Maintenance
Cleaning and Lubrication: Remove dust and foreign matter from the lead screw, blade, blade holder, tool holder, and guide pins, and apply lubricant (sewing machine oil or heavy-duty gear oil is recommended).
Oil Level Check: Observe the lubricant level through the oil sight glass to ensure it is at the middle mark. Refill if insufficient.
Safety Check: Verify that the equipment is properly grounded and the emergency stop button is functioning properly.
2. Weekly/Biweekly Maintenance
Transmission Component Lubrication: Lubricate the transmission chain and gears and check for loose screws.
Tool Inspection: Observe blade wear. Tungsten carbide blades should be replaced every 50 km of cutting, and ceramic blades should be stored to prevent impact.
3. Monthly Advanced Maintenance
System Calibration: Adjust the tool gap (e.g., 2-3 mm) and the tension system (fluctuation ≤ ±0.5 N) to ensure slitting accuracy. Correction System Test: Verify the correction function of the CCD vision or infrared sensor (accuracy must be ±0.1mm).
4. Long-Term Maintenance Recommendations
Oil Change Interval: The first oil change should be after 1000 hours of operation, and every 3000 hours or annually thereafter. Drain any old oil thoroughly and clean the oil filler hole.
Environmental Management: Keep the equipment area clean to prevent iron filings and dust from entering the oil seals or transmission system.
5. Abnormal Handling
Fault Identification: If abnormal vibration, noise, or unstable cutting occurs, immediately stop the machine and check the oil level, cutting tool, or transmission components.
Professional Repair: Contact the manufacturer for repairs in the event of internal cam or bearing damage. Unauthorized disassembly is prohibited.
Precautions
Lubrication Specifications: Do not mix different brands of lubricants. Select the appropriate viscosity oil based on the ambient temperature.
Operational Safety: Turn off the power supply during lubrication or maintenance, and avoid contact with moving parts. Record management: Create a maintenance log to record oil change dates, problem resolution, etc. to facilitate tracking of equipment status.






