1. After the die setting work of Aluminum Foil Slitting Rewinding Machine is completed, put the material to be cut on the rubber sheet, then put the die on the material, and then push the feed plate into the cutting area.
2. Press the cutting switch of the rewinder with both hands. At this time, the cutting pressure plate will be lowered and pressurized on the die. After the die cuts the material, it will automatically return to the position before starting and stop.
3. When cutting materials with a non-woven cross-cutting machine, if you find that the material has not been cut, adjust the cutting depth controller to rotate the "pressure system" clockwise and counterclockwise; if the die is pressed into the rubber sheet too deeply, Rotate the "pressure system" counterclockwise, the longer the adjustment time, the deeper the cut, and try to adjust until the die is slightly pressed into the rubber sheet.
4. Pull the feeding plate out of the cutting area, take out the cut material, and complete the blanking process.
