The central part of the slitting machine is installed with the main shaft for processing the paper tube, the front end of the main shaft is fixed on the base with a set of bearings, and a pulley is installed in the middle of a set of bearings; a compression cylinder is installed near the base, and the support rod of the cylinder is A set of support rod bearings is installed on the upper end to support the main shaft.
A main cutter shaft is installed on the upper end of the slitting machine, and several blades are arranged on it and arranged according to a certain gap; a support frame of the main cutter shaft is also arranged at the top of the slitting machine, and a support is installed in the middle of the supporting frame cylinder.
When there is film on the slitting machine and the reel joint is changed, use the vacuum film splicing stage to start the film splicing stage to the working position, manually flatten the film on the first traction roller of the slitting machine and start the upper vacuum pump to suck the film, so that the film Adsorb the film flatly on the film splicing table, paste the double-sided tape and cut off the excess film under the tape, flatten the film on the unwinding rack and start the lower vacuum pump to make the film flat and adsorb, take off the paper layer on the tape and flatten it. The mucosa and joints should be neat and wrinkle-free, then turn off the upper and lower vacuum pumps, and open the film connection table to the non-working position.
