Knowledge

Types of Common Lubrication System Faults 1. Lubrication Device Not Spraying Oil This is one of the common faults in aluminum cutting machines. Micro-lubrication devices may stop s

1. Daily Maintenance (After each start-up/shutdown) Check oil level: Ensure the oil level in the tank is between the upper and lower limits; add the same type of lubricating oil if

1. Daily Maintenance This should be performed before each startup and after each shutdown, including checking oil levels, pipeline leaks, and operating sounds. It is quick but allo

I. Daily Cleaning and Basic Inspection Aluminum Chip Removal: After each use, promptly remove aluminum chips from the workbench, saw blade entry point, and inside the equipment to

Replacement Steps: 1. Disconnect the power: This is the most crucial step. Ensure the slitting machine is completely powered off and the power plug is unplugged to prevent accident

I. Cutter-Related Faults 1. Blade dullness or wear Solution: Replace the blade promptly and regularly check the blade sharpness. Rewinding slitting machine paper roll not cut: Chec

I. Daily Maintenance 1. Cleaning and Dust Removal Daily, use a soft brush or vacuum cleaner to clean the surface and interior of the equipment, removing metal shavings and dust to

1. Pre-operation Preparation Equipment Inspection Check that the mechanical and electrical systems are functioning properly, and confirm that protective devices (such as protective

I. Electrical System Maintenance 1. Power Supply and Wiring Inspection Regularly check the power cord and plug for aging and damage, and ensure proper grounding to avoid short circ

Common Foil Cutting Machine Failures I. Electrical System Failures 1. Machine Failure to Start Check the power connection for security and the fuse for a blown 2A/6A fuse. Test the

I. Daily Basic Maintenance 1. Lubrication System Inspection Check that the 20# air compressor lubricant in the oiler is 70% full and the pressure is maintained between 6 and 7. Ens

1. Duration of Different Maintenance Cycles Daily Maintenance Basic Cleaning and Inspection: Approximately 5-10 minutes, including lens wiping, guide rail lubrication, and waste re